CLEANING PROCEDURES


1. Initial Cleaning

  • Remove all surface soil, debris, sand, and grit by sweeping, dust mopping, or vacuuming.
  • Scrub floor with E-Cleaner, using low speed rotary scrubber or auto scrubber with
    Microfiber mop, Soft Nylon Brush or pad per table above.
  • Pick up solution with a wet vacuum, rinse with clean water, and allow to dry thoroughly (6-8
    hours).

2. Daily/Regular Cleaning

  • Remove all surface soil, debris, sand, and grit by sweeping, dust mopping, or vacuuming.
  • Damp mop with a microfiber mop or scrub floor with E-Cleaner, using low speed rotary
    scrubber or auto scrubber with Microfiber mop, Soft Nylon Brush or pad per table above.

3. Heavy Soil

  • Hard-to-clean areas may require a higher concentration of E-Cleaner and may even require
    restorative maintenance (below).

4. Restorative Maintenance

Restorative maintenance is not needed until there is a noticeable accumulation of dirt and contaminant build up. Normally this accumulation occurs in hard-to-reach and high traffic areas. A good maintenance program will minimize the frequency of restorative cleanings.

  • Sweep or vacuum to remove loose soil.
  • Heavy scrub using a rotary low-speed scrubber or auto scrubber with pad per table above
    and E-Strip diluted per table above.
  • Pick up solution with wet vac.
  • Rinse with clean water.
  • Allow floor to thoroughly dry.

 

WEAR SAFETY GLASSES and rubber or latex gloves when mixing, pouring or applying ECOguard. Wash hands with soap and water after contact.